![]() ![]() Once you see your Miracast device you can select it and let your system and device be paired for use - your local display will then be broadcast to your external display.If you do not see your adapter listed as a selection, you will need to select add a wireless display option at the bottom of the list and your system will automatically detect your device ![]() Now select Project (the bottom option) and the Project Menu will appear with your Miracast device displayed.Select the Devices Charm (4th charm from top) and the Devices Menu will slide out from the right side of the screen.(The Charms menu will slide out from the right side of the screen.) From the Start Screen press the Windows Key + C to Open the Charms Menu.Now follow these steps to connect to your adapter: Once your Miracast adapter is properly connected you should see a message on your display or TV telling you that the device is ready. To Ensure the Miracast receiver you purchase is Wi-Fi certified.Ĭonnect your Miracast receiver to your display or TV by following the manufacturers install instructions. If the driver model is then continue following the instructions in section 4. If the driver model does not state WDDM 1.3, your system is not Miracast ready. You will see the Driver Model at the bottom of the right hand column. When the DirectX Diagnostic ToolPage opens, select the Display Tab (or the next page button near the bottom of the window).In the Run dialogue box type: " dxdiag" and press the Enter Key.To check to ensure your graphics drivers are Miracast capable: If it is continue on to the next step once you have exited Power Shell by typing exit. If the results show that the NdisVersion is not 6.3 or greater, the system is not Miracast ready. The results that should display will have a line entry for each type of network adapter in the system (Wireless, Bluetooth and Ethernet) and each line with end with the NDIS version.You will see the following prompt: (PS C:UsersDell_000>) Type the next command: " Get-netadapter|select Name, ndisversion" Now at the C:> prompt type powershell and press the Enter Key to get into powershell mode.Les pilotes WDDM 1. Right click on Start select RUN and type " CMD" in the run box to open a command prompt ( C:>). Prise en charge de Miracast dans Windows 8.1.To check to see if your Network driver is Miracast capable.Once all drivers updated, continue to step 2 below: Go to Select your system, select window 8.1 as your operating system (OS), then Update all your Dell drivers to Windows 8.1 versions available.To see if your system is Miracast capable follow these steps: (Omit the quotation marks when typing the commands on command line or powershell.) Your WIFI driver must be Network Driver Interface Specification (NDIS) 6.3 or newer.You must have Windows Display Driver Model (WDDM) 1.3 Graphics drivers.Your Wi-Fi receiver must be Wi-Fi Certified.The Miracast receiver used must be Wi-Fi certified for the technology to work. Miracast enables wireless delivery of compressed standard or high-definition audio and video to or from desktops, tablets, mobile phones, and other devices. Miracast is a peer to peer wireless screencast standard formed by a Wi-Fi direct connection similar to Bluetooth or WiDi that Microsoft is supporting under Windows 8.1. If you have this need, you can download it from the official website.This article contains information regarding Miracast and how to make it work in Windows 8 MiniTool Partition Wizard can help you clone the operating system, manage disks, and recover data. How to Update Device Drivers Windows 10 (2 Ways) Bottom Line Then, follow the on-screen instructions to use Miracast. After that, you need to connect the screen sender and receiver to the same wifi, select the Network icon on the right side of the taskbar, select Cast, and pick your display or adapter. Of course, you can also use Device Manager to update them. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |